How To

Install Peel & Stick Wallpaper

Download Printable Instructions

PRIOR TO GETTING STARTED

Inspect each roll for any possible print defect and make sure rolls have the same run/lot number for exact color matching prior to cutting and hanging.

Be Advised: Areas with high humidity, such as bathrooms and kitchens, are more prone to peel and stick wallpaper bubbling and seam separation. Extreme temperature fluctuations, such as rapid shifts can impact the performance of peel and stick wallpaper.

SURFACE PREPARATION

For best results, clean, dry and smooth all Product will not adhere to unclean, textured, or nonstick surfaces. Allow newly painted surfaces to fully cure for a minimum of 4 weeks before applying this peel & stick wallpaper.

If you are hanging this product around sockets or switches, turn off main power, unscrew fixtures & clean out all dust prior to hanging wallpaper as this will negatively affect adhesion.

HANGING (IT HELPS TO HAVE TWO PEOPLE)

Step 1: Tools Required

Tape Measure
Level
Steel Ruler or Straight Edge
Razor Knife
Pencil
Plastic Smoother

Step 2: Draw Your line

Beginning on the left side of your wall, measure out from the corner the width of the paper and mark the wall lightly with a Using your level, draw a straight line down. This is the guide for your 1st strip, and it is very important for it to be a straight, vertical line.

If you are hanging this product around sockets or switches, switch off main power, unscrew fixtures & clean out all dust prior to starting as this will negatively affect adhesion.

Any damp issues must be corrected before application of this wallcovering.

Step 3: Cut Your First Strip

Step 4: Remove Backing

Peel about 12” to 24” (30.48cm to 60.96cm) of the backing away from the top of the paper. Apply the paper to the top of the wall, allowing a bit of excess to overlap the ceiling which will be trimmed off later. Align the right side of the strip to your mark and lightly press the edge to the wall along the mark. You can reposition if needed to ensure a vertical seam.

Step 5: Apply to Wall

Working from top to bottom, pull the backing away as you evenly press the paper to the wall a few inches at a time. Be careful not to pull or stretch the material or the pattern will not align. For best results, have one person guide the paper at the top and along the seam, while another holds the opposite edge away from the wall until the seams are lined up.

Using a plastic smoother, work your way down the strip in a back and forth motion, smoothing the material to the wall and pushing out any air bubbles (work them out from the center to the edge of the strip). Firm pressure must be applied to ensure air bubbles are removed and the wallpaper properly adheres to the wall.

Note: If bubbles reappear, work them out by applying firm pressure with smoother.

Step 6: Strim

Step 7: Match Next Strip

For Best Results

Apply onto smooth and clean surfaces using a smoothing tool applying firm pressure. Do NOT apply onto freshly painted or papered walls (let paint or wallpaper dry for at least 4 weeks). Do NOT apply to lacquered furniture. The fading of furniture exposed to sunlight is not related to the use of our product. May not work on heavily textured surfaces. Test in an inconspicuous area before applying to wallpaper or other delicate surfaces. Keep decorations away from cribs and out of reach of young children to prevent choking hazard.

CLEANING
Peel & Stick Wallpapers are washable and can be cleaned using a mild detergent and a damp sponge or cloth.

Your Cart (0)